18
OPERATING THE LASER LIGHT
LASER SWITCH
WARNING: DO NOT STARE DIRECTLY AT THE LASER BEAM. ONLY TURN
DANGER: NEVER ALLOW THE LASER
BEAM TO SHINE INTO A PERSON’S EYES.
SERIOUS EYE DAMAGE COULD RESULT.
THE LASER BEAM ON WHEN THE SAW IS ON THE WORKPIECE.
1. Mark the cutting line.
2. Remove the battery from the saw.
3. Insert battery and press the separate ON switch to turn on the laser.
This saw is equipped with a laser guidance system
for more precise cutting.
To turn the laser ON, press the laser switch (1)
once (Fig. 18). To turn the laser OFF, press the
laser switch again.
4. Align and/or adjust the laser beam with the mark on the workpiece.
5. Squeeze the trigger switch and slowly push the saw forward, using both
when you have finished cutting.
MAINTENANCE
WARNING: Always remove battery pack from your tool when you are
assembling parts, making adjustments, cleaning, or when not in use.
Removing battery pack will prevent accidental starting that could cause
serious personal injury.
WARNING: When servicing only use identical replacement parts. Use of
any other parts may create a hazard or cause product damage.
WARNING: Always wear safety goggles or safety glasses with side shields
during power tool operation or when blowing dust. If operation is dusty, also
wear a dust mask.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to
damage from various types of commercial solvents and may be damaged by their
use. Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING: Do not at any time let brake fluids, gasoline, petroleum-based
products, penetrating oils, etc., come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may result in serious personal injury.
20V BRUSHLESS 7-1/4" CIRCULAR SAW
1265-002
1
FIG.18
To Next Page
Loading...
