14
Pull
Push
FIG. 7
• Avoid unintentional contact with the stationary saw chain or guide bar rails.
These can be very sharp. Always wear gloves and long pants or chaps when
handling the chainsaw, saw chain, or guide bar.
• Never operate a chainsaw that is damaged or improperly adjusted or that is not
completely and securely assembled. Be sure that the saw chain stops moving
when the trigger switch is released.
• When bucking, secure the work piece prior to cutting. When felling or pruning,
identify and secure hazardous branches.
• Aggressive or abusive cutting or misuse of the chainsaw can cause premature
bar, chain, and/or sprocket wear, as well as a broken chain or bar, leading to
kickback, chain throw or the ejection of material.
• Never use the guide bar as a lever. A bent guide bar can cause premature bar,
chain, and/or sprocket wear, as well as a broken chain or bar, leading to kickback,
chain throw or the ejection of material.
• Cut only one work piece at a time.
• Use only with the battery packs and chargers listed below:
BATTERY PACK CHARGER
5350-018 / YF60VRX2.5-BAT 5350-020 / YF60VRX2A-CHG
5350-019 / YF60VRX4.0-BAT 5350-021 / YF60VRX4A-CHG
• Do not charge the battery pack in rain or in wet locations.
• If situations occur which are not covered in this manual, use care and good
judgment. Contact Customer Service for assistance.
60V 16-INCH CORDLESS CHAINSAW
52 40-050
To Next Page
Loading...