20
Insert the battery pack (Fig. 19).
To install the battery pack, align the tongue on the battery pack with the groove
in the housing and slip it into place.
NOTE: Always insert it all the way until it locks in place with a little click. If not, it
may accidentally fall out of the tool, causing injury to you or someone around you.
FIG. 19 FIG. 20
Remove the battery pack
1. Depress the battery releasing/locking button on the housing.
2. The battery pack will pop up automatically.
3. Lift and hold the battery pack while pressing the releasing/locking button again,
and then remove the battery pack.
NOTE: The second operation that needs to be performed when removing the
battery pack is to avoid any mis-operations at work, especially for the Benchmark
60V hand-held tools, in case the battery pack falls and hurts consumers (Fig. 20).
NOTE: Do not use force when installing the battery pack. If the battery pack does
not slide in easily, it is not being inserted correctly.
WARNING: Verify that the switch is in the OFF position before inserting or
removing the battery pack.
WARNING: Verify that the battery pack is removed and the switch is in the OFF
position before inspecting, adjusting or performing maintenance on any part of the
chainsaw.
Starting/stopping the chainsaw
NOTE:
1. Before starting the chainsaw, check for the oil level, saw teeth sharpness and
properly working kickback brake handle.
2. Besides, balanced footing and proper distance away from the ground are needed.
52 40-050
60V 16-INCH CORDLESS CHAINSAW
To Next Page
Loading...