18
• During normal saw operation, the temperature of the chain will increase. The drive
links of a correctly tensioned warm chain will hang approximately 0.08" (2 mm)
out of the bar groove (Fig. 15).
NOTE: New chains tend to stretch; check chain tension frequently and tension as
required.
NOTE: A chain tensioned while it is warm may be too tight upon cooling. Check
the cold tension before next use.
Filling bar and chain lubricant oil (Fig. 16).
FIG. 16
WARNING: Do not smoke or bring any fire or flame near the oil or the chainsaw.
Oil may spill and cause a fire.
NOTE: The chainsaw is not filled with oil at the time of purchase. It is essential to
fill the tank with oil before use.
The chain is automatically lubricated with chain oil during operation.
1. Position the chainsaw on its side with its oil tank cap facing towards.
2. Clean the cap as well as the area around and then turn it counter-clockwise
to remove.
3. Carefully pour the specifically designed oil into the tank until reaching the
bottom of the filter neck.
4. Wipe o any excessive oil and replace the cap.
NOTE: With upright position, oil should fill the inspection window. When the oil is
no longer visible in the inspection window, stop use immediately and refill.
Charging the battery pack
NOTE: Remove the battery pack from the charger after it has been fully charged.
NOTE: Battery should be fully charged before first use.
NOTE: Make sure the mains voltage is the same as the rating label which is located
on the charger.
1. Connect the charger to a power supply. The red LED will light up.
2. To insert the battery pack into the charger, align the raised ribs of the battery
pack with the grooves of the charger then push it in (Fig. 17).
52 40-050
60V 16-INCH CORDLESS CHAINSAW
To Next Page
Loading...