15
cursor to the Day position. Enter the Day using the PROGRAM button. Depressing
the NEXT button will move the cursor to the Year position. Depressing the
PROGRAM button will increment the Year from 00 to 99. Depressing the NEXT
button will move the Cursor the Hour position. The time is set in 24-Hour format.
Depressing the PROGRAM button will increment the Hour from 00 to 24 Hours.
Depressing the NEXT button will move the cursor to the Minutes position.
Depressing the PROGRAM button at this time will increment the minutes from 00 to
59. Depressing the NEXT button will go to the next option, “ENTER MACHINE
NUMBER”
6.) “ENTER MACHINE NUMBER”
The machine number for each unit can be set from 0 to 99. Depressing the
PROGRAM button will increment this value, and depressing the NEXT button will
move to the next option, BarCode entry.
7.) “ENTER BARCODE?”
Depressing the PROGRAM button will allow for entry/editing of the 4-Digit
Interleaved 2 of 5 barcode present on the ticket for ticket validation. Depressing the
NEXT button will skip this step.
8.) “BARCODE: 0000”
This option sets the 4-Digit barcode. The flashing cursor will be over the first digit.
Depressing the PROGRAM button will change the value of this digit from 0 to 9 then
back to 0. Depressing the NEXT button will move the cursor to the next digit.
Continue in this manner until the last digit is entered, then depressing the NEXT
button will move to the next option, “TICKET SECURITY”.
9.) TICKET SECURITY
This option sets the Level of ticket barcode validation used. The PROGRAM button
will change the value from 0 to 2, then back to 0, and the NEXT button will move to
the next option, “SAFETY MODE”. The Three security levels are as follows:
LEVEL 0 – Notch Only Validation, no Barcode required
LEVEL 1 - Barcode Validation, Standard (Recommended)
LEVEL 2 – Barcode Validation, HIGH Security
10.) SAFETY MODE
This option sets the Safety Level of the ticket eaters. Off is the normal mode and is
recommended. ON lessens the power of the ticket eaters. Depressing the PROGRAM
button changes the setting, and depressing the NEXT button moves to the next option,
“RE-ENTER PROGRAM MODE?”
11.)RE-ENTER PROGRAM MODE?
This option give you the opportunity to go through the programming settings again.
Depressing the PROGRAM button will re-enter the Program Mode at the beginning,
and depressing the NEXT button will leave Program Mode, and return to Run Mode.
To Next Page
Loading...
Need help?
General