Bender ISOSCAN W Series - Operation; Reading out and Setting the BS Address; Reading out a BS Address

ISOSCAN® EDS440 and EDS441
8 Operation
8.1 Reading out and setting the BS address
If the BS address is set to 0, the device goes into the trigger mode “auto”. See “Trigger function”,
page 51.
8.1.1 Reading out a BS address
-1
>3sADDR.
RESET
+1
+10
TEST
CHANNELS / ADDR.
12
11109
87
345621
+10 +20 +40
Addr. Mode
n
∆
I
ALARM
L
∆
I
ALARM
SERVICE
COM/ADDR.
ON
1 x
-1
>3sADDR.
RESET
+1
+10
TEST
CHANNELS / ADDR.
12
11109
87
345621
+10 +20 +40
Addr. Mode
n
∆
I
ALARM
L
∆
I
ALARM
SERVICE
COM/ADDR.
ON
Address: 2
The current address is displayed with the “COM/ADDR.” LED lit and the channel LED for 4 seconds. If the device
is in an extended address range (80...158), the address is displayed with the “COM/ADDR.” LED flashing and the
channel LED. See “Extended address range (offset = 80)”, page 46.
EDS44x_D00201_10_M_XXEN/11.2023 43