JAW TERMINAL WIRE SIZE
INSULATION RANGE
A
030-1107-30
18 to 24 AWG
.110
to
.055
B
030-1107-30
24 to 30AWG
.055
to
.030
KING
KY 196/196E/KY 197/197E
VHF COMMUNICATIONS TRANSCEIVER
Holding the hand
crimpers
as shown, release the crimper's ratchet pawl and open by squeezing tightly
on the handles, and then releasing pressure.
HAND CRIMPER
KPN 071.6041-00
MOLEX
PIN
6115
Close crimpers until ratchet begins to engage. Then insert the terminal into the jaws from the back
side. (See Figures at bottom of page)
For 24 to 30AWG wire, it will be necessary to start the crimp
in jaw A and then complete it in jaw B;
, WIRE STOP
Terminal is in correct position when insulation tabs are flush with outside face of crimp jaws.
FIGURE 2-1 MOLEX TERMINAL AND TOOLS
(Dwg. No. 696-6333-00, R-1)
(Sheet
2 of 3)
Rev. 2, June, 1982
IM0007-4
Page 2-5
To Next Page
Loading...
