EasyManuals Logo

BENDIX 360CC User Manual

BENDIX 360CC
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
A-15
1. Ensure that the governor control line from the
reservoir is located at or near the top of the res-
ervoir. (This line, if located near the bottom of
the reservoir, can become blocked or restricted
by the reservoir contents e.g. water or ice.)
Bendix
®
Compressors: Park vehicle, chock
wheels, and follow all standard safety procedures.
Remove the governor and install a tting to the
unloader port. Add a section of air hose (min
1 ft long for a 1/2" diameter line) and a gauge
to the tting followed by a shut-off valve and an
air source (shop air or small air tank). Open the
Test 5: Governor Control Line
Test 6: Compressor Unloader Leakage
1. Inspect control lines to and from the governor
for restrictions (e.g. collapsed or kinked).
Repair as necessary.
2. Using a calibrated external gauge in the
supply reservoir, service reservoir, or reservoir
port of the D-2
®
governor, verify cut-in and
cut-out pressures are within vehicle OEM
speci cation.
3. If the governor is malfunctioning, replace it.
Tests (continued)
Test 4: Governor Malfunction
2. Perform proper reservoir drain intervals and air
dryer cartridge maintenance per Maintenance
Schedule and Usage Guidelines (Table A on
page A-3).
3. Return the vehicle to service.
shut-off and charge the unloader port by allowing
air pressure to enter the hose and unload the
compressor. Shut off the air supply and observe
the gauge. A steady reading indicates no leakage
at the unloader port, but a falling reading shows
that the unloader mechanism is leaking and needs
to be serviced.
Note: This Test is not applicable for the compressor
featured in this SD sheet —- information is shown for
reference only.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the BENDIX 360CC and is the answer not in the manual?

BENDIX 360CC Specifications

General IconGeneral
BrandBENDIX
Model360CC
CategoryAir Compressor
LanguageEnglish

Related product manuals