BENDIXKing XCRUZE 110 - Introduction; How to Use This Manual

_____________________________________________________________________________________
8300-088 AeroCruze 110 Installation Manual
Rev 1 Page 1
© Honeywell International Inc. Do not copy without express permission of Honeywell.
1 INTRODUCTION
1.1 How to Use This Manual
1.1.1 General
(1) This publication gives installation and maintenance instructions for the equipment shown on the
Title page.
(2) Standard maintenance procedures that technicians must know are not given in this manual.
(3) Warnings, cautions, and notes in this manual give the data that follows:
A WARNING gives a condition or tells personnel what part of an operation or
maintenance procedure, which if not obeyed, can cause injury or death.
A CAUTION gives a condition or tells personnel what part of an operation or
maintenance procedure, which if not obeyed, can cause damage to the equipment.
A NOTE gives data, not commands. The NOTE helps personnel when they do the related
instruction.
(4) Warnings and cautions go before the applicable paragraph or step. Notes follow the applicable
paragraph or step.
1.1.2 Observance of Manual Instructions
(1) Make sure that you carefully obey all safety, quality, operation, and shop procedures for the unit.
(2) All personnel who operate equipment and do maintenance specified in this manual must know
and obey the safety precautions.
1.1.3 Symbols
(1) The symbols and special characters are in agreement with IEEE Publication 260 and IEC
Publication 27. Special characters in text are spelled out.
(2) The signal mnemonics, unit control designators, and test designators are shown in capital letters.
(3) The signal names followed by an “*” show an active low signal.
(4) The symbols in Error! Reference source not found. show ESDS and moisture sensitive devices.
Figure 1-1 Symbols