BENDIXKing XCRUZE 110 - Garmin GPS 396;496 Configuration; Lowrance Airmap 100 Configuration; Lowrance Airmap 1000;2000 Configuration

To Next Page

To Previous Page

_____________________________________________________________________________________

8300-088 AeroCruze 110 Installation Manual

Rev 1 Page 15

Now the Garmin 296 is correctly set up to provide the RS-232 serial output required by your TruTrak

autopilot.

9.6 Garmin GPS 396/496

The Garmin 496 must be configured to provide the correct output to the autopilot.

Press the MENU key twice. Use the rocker keypad to select the SETUP in the vertical tabs. Use

the rocker keypad to select the ‘Interface’ tab.

Press the down portion of the rocker keypad to select the ‘Serial Data Format’ field.

Press ENTER and a popup window will show the available settings.

Use the rocker keypad to select ‘NMEA IN / NMEA OUT’ then press ENTER. Select 4800 for the

baud rate. Note: This is the baud rate that will need to be entered in the setup mode of the

autopilot.

Press MENU to enter the Advanced NMEA page. Select ‘Advanced NMEA Setup’ and press

ENTER.

Using the arrow keypad and the ENTER key to select “FAST OUTPUT” or turn OFF ‘GPS Status

(GSA, GSV)’, ‘Waypoint/Route (WPL, RTE)’, and ‘GARMIN Proprietary’.

Now the Garmin 396 / 496 is correctly set up to provide the RS-232 serial output required by your

TruTrak autopilot.

9.7 Lowrance Airmap 100

The Lowrance Airmap 100 requires a NMEA/DGPS adapter cable to provide data output. The Lowrance

Airmap 100 must be configured to provide the correct output to the autopilot.

Press the MENU key then select “NMEA/DGPS CONFIG” from the “System Setup” menu.

Highlight the “NMEA OUT” menu then press the right arrow key.

Note: The default baud rate is 4800. This is the baud rate that will be entered into the autopilot

in the setup mode.

Now the Lowrance Airmap 100 is correctly set up to provide the RS-232 serial output required by your

TruTrak autopilot.

9.8 Lowrance Airmap 1000/2000

The Lowrance Airmap 1000/2000 requires a NMEA/DGPS adapter cable to provide data output. The

Lowrance Airmap 1000/2000 must be configured to provide the correct output to the autopilot. Airmap

has one NMEA 0183 version 2.0 compatible communication port,

Press MENU|MENU|↓ to SYSTEM SETUP|ENT. Press ↓ to COMMUNICATIONS PORT|ENT.

Select 9600 Baud. This is the baud rate that will be entered into the autopilot in the setup

mode. Select “NMEA OUT”

Now the Lowrance Airmap 1000/2000 is correctly set up to provide the RS-232 serial output required by

your TruTrak autopilot.