Autostacker™ Parking Lift 13 P/N 5900002 — Rev. D — August 2019
Installation
This section describes how to install your Autostacker. Perform the steps in the order listed.
⚠ WARNING
Only use the factory-supplied parts that came with your Lift
. If you
use parts from a different source, you void your warranty and compromise the
safety of everyone who installs or uses the Lift. If you are missing parts, visit
autostacker.com/support or call (888) 977-8225.
Safety Rules
When installing your Autostacker, your safety depends on proper training and thoughtful operation.
⚠ WARNING Do not install this equipment unless you have automotive lift installation training.
Always use proper lifting tools, such as a Forklift or Shop Crane, to lift heavy
components. Do not install this equipment without reading and understanding
this manual and the safety labels on the unit.
Only fully trained personnel should be involved in installing this equipment.
Pay attention at all
times.
Use appropriate tools and lifting equipment, when needed. Stay clear of moving parts.
BendPak recommends referring to the current version of the ANSI/ALI ALIS Standard Safety
Requirements for Installation and Service for more information about safely installing, using, and
servicing your Lift.
⚠ WARNING You must wear appropriate protective equipment
at all times
during
installation: gloves, steel-toed work boots, eye protection, back belts, and
hearing protection.
Tools
You may need some or all of the following tools:
• Rotary hammer drill or similar
• 3/4", 3/8" masonry bits
• Hammer and crow bar
• Open-end wrench set
• Socket and ratchet set
• Medium crescent wrench
• Chalk line and tape measure
• Medium flat screwdriver
• Fork lift or Shop Crane
To Next Page
Loading...
