Autostacker™ Parking Lift 3 P/N 5900002 — Rev. D — August 2019
Table of Contents
Introduction 3 Installation
13
Shipping Information 4 Operation
41
Safety Considerations 4 Maintenance
47
FAQ 6 Troubleshooting 4
8
Specifications 7 Multi-Autostacker
51
Components 8 Wiring Diagrams
68
Will My Cars Fit? 10 Labels
74
Orientation 11 Parts Diagrams
80
Installation Checklist
12
Introduction
This manual describes both Autostacker versions, which can easily and quickly raise a Vehicle so that
you can park a second Vehicle underneath.
Autostacker raises Vehicles up to 6,000 lbs (2,722 kg). For more information about Autostacker, visit
autostacker.com.
Autostacker is available in two versions:
• PL-6SR. Parking Lift that allows you to make a parking spot that holds just one Vehicle into a
parking spot that holds two Vehicles, lifting vehicles up to 6,000 lbs (2,722 kg).
• PL-6SRX. Wide version of the PL-6SR, with an extra 8 inches of width for your Vehicles.
Autostacker is available in a
Multi-Lift
configuration, where you can control up to 12 Lifts using a
single Master Power Unit.
Unless specifically stated, the setup for each Autostacker in a Multi-Lift configuration follows the same
installation process as a single Autostacker. The main differences include separate procedures for
routing the Hydraulic Hoses and Return Line to a Master Power Unit, in addition to installing a Control
Stand to each Lift that allows you to operate a specific Lift in your lineup; see Multi-Autostacker
towards the end of this manual for those modified procedures and any additional information.
After you have completed those modified procedures, continue the remainder of the installation as you
would with a single Autostacker; see the Installation Checklist for an overview of the installation
process.
This Manual is mandatory reading for
all Autostacker Lift installers and users
.
To Next Page
Loading...
Need help?
General
