Autostacker™ Parking Lift 41 P/N 5900002 — Rev. D — August 2019
Operation
This section describes how to operate your Autostacker.
⚠ WARNING Always use care when you are around the Autostacker. When it is lowered, be
careful not to trip over it. When it is raised, be careful not to bang your head on the
Drive-Up Ramp or Platform.
When the Autostacker is moving, keep all
people, animals, and objects at least 30 feet away
from it.
Preparing to Raise or Lower a Vehicle
Before you raise or lower a Vehicle using Autostacker, do the following:
• Check the Autostacker. Check the Autostacker for any missing, heavily worn, or damaged
parts. Do not operate the Autostacker if you find any issues; instead, take the Lift out of service,
then contact your Autostacker dealer, visit autostacker.com/support, email
support@autostacker.com, or call Autostacker at (888) 977-8225.
• Check the area. Check the area around the Autostacker for obstructions; anything that might
block the lift. Do not forget to check
above
the Autostacker. If you find an obstruction, move it out
of the way. Do not allow people or animals within 30 feet of the Autostacker while it is in motion.
• Check the operators. Make sure that everyone who is going to operate the Autostacker has
been trained in its use, has read the labels on the unit, and has read the manual. Only the operator
at the Console should be within 30 feet of the Autostacker when it is in motion.
• Check for safety. Make sure everyone who is going to be walking near the Autostacker is
aware of its presence and takes appropriate safety measures. Only put Vehicles on the Platform.
When raising the Autostacker, do not leave it until it is on a Safety Lock
. When
lowering the Autostacker, do not leave it until it is on the ground. Do not allow children to operate
the Lift. Do not allow anyone under the influence of drugs or alcohol to operate the Lift.
The Autostacker Console
Your Autostacker is controlled via its Console.
The parts of the Autostacker Console are:
• Emergency Stop button. Press to immediately stop the Autostacker from moving. This button
is for use in unexpected or dangerous situations.
• On/Off key. Insert the key and turn it to On when you want to raise or lower the Lift. Set it to Off
and remove the key when the Lift is not in use.
Do not leave the key in all the time
; this is a
security and safety risk.
• Up button. Press and hold Up to raise the Lift. Release Up to stop the Lift from going up.
• Down button. Press and hold Down to lower the Lift. Release Down to stop the Lift from going
down. The alert sound goes on automatically when the Lift is moving down.
To Next Page
Loading...
Need help?
General
