Autostacker™ Parking Lift 40 P/N 5900002 — Rev. D — August 2019
Final Checklist
Make sure these things have been done before using your lift:
• Review the Installation Checklist to make sure all steps have been performed.
• Make sure the Power Unit is getting power from the power source.
• Check the Power Unit’s Hydraulic Fluid reservoir; it must be full of approved Hydraulic Fluid or
automatic transmission fluid. You can harm the motor by running it without enough fluid.
• Check the Hydraulic System for leaks.
• Check to see that all Anchor Bolts are properly tightened.
• Make sure that all Safety Locks are cleared and free.
• Make sure a copy of the Installation and Operation Manual is left with the equipment, so that it is
available to all operators, and make sure all labels are visible.
• Raise the Autostacker to each of the six Safety Locks and measure the space between the ground
and the bottom of the Drive-Up Ramp. Check these values against the values shown in Raising a
Vehicle. These are the actual values that you should use to determine what Vehicles you want to
put where.
• Perform an operational test of the Lift with a typical Vehicle.
During the operational test, observe all operating components and check for proper installation and
operation. Do not raise any additional vehicles until a thorough operational check has been
performed with a typical Vehicle.
If the Autostacker fails the operational test, take it out of service, then consult Troubleshooting
to begin addressing the problem.
To Next Page
Loading...
