Autostacker™ Parking Lift 39 P/N 5900002 — Rev. D — August 2019
Lubricate the Lift
The Autostacker has eight Lubrication Points, four on each Leg Assembly.
You must grease the Threaded Grease Fitting at the Lubrication Points before you start normal
operation of your Autostacker. Refer to Maintenance for more information about how often to
grease the Lubrication Points after the start of normal operation.
Tip Autostacker recommends using white lithium grease, or similar, and a grease gun
with an appropriate tip (a Lube-Link™, for example) when lubricating your lift.
The Threaded Grease Fittings / Lubrication Points on each Leg Assembly are:
• Where the bottom of the Cylinder meets the Base
• Where the top of the Cylinder meets the Leg
• On the underside where the two Legs cross
• Where the Leg meets the Top Connector Tube
To Next Page
Loading...
