Autostacker™ Parking Lift 19 P/N 5900002 — Rev. D — August 2019
Position the Autostacker Components
When the Lift components are delivered to the site, try to have them placed near where you will be
installing the unit. For example, if you are installing Autostacker in a garage, you might want to have the
components unloaded on the garage’s driveway or inside the garage.
⚠ CAUTION Some of the Autostacker components are heavy and can damage materials like tile,
sandstone, and brick if not handled correctly. Try to handle the Autostacker
components only twice: once when delivered and once when moved into position.
Once delivered, remove the packaging and prepare for installation.
⚠ WARNING Some of the Autostacker components are very heavy. You must have a Forklift or
Shop Crane to move them into position. Use care when moving them around.
Autostacker components include:
• Two Leg Assemblies: Each Leg Assembly includes a Base, Leg, Hydraulic Cylinder, and
Platform Arm.
• Bottom Connector Tube: Connects to the Leg Assembly Bases. The Hydraulic Hoses and the
Return Line are routed through the hollow Bottom Connector Tube.
• Top Connector Tube: Connects to the Leg Assembly Platform Arms. Also attaches to the Tire
Trough.
• Tire Trough: A single piece with a lowered portion (to hold the Vehicle’s tires from moving, which
holds the Vehicle in place). Attaches to the Top Connector Tube and the first Platform section at
the front of the Autostacker.
• Platform: Made up of galvanized steel sections that are bolted together.
• Ramp: A single piece, angled for easy drive-up.
To move the Leg Assemblies into position:
1. Use a Forklift or Shop Crane to move the Leg Assembles into position based on the Chalk Lines.
The Leg Assemblies go on the
inside
of the Chalk Lines.
⚠ CAUTION Some of the Autostacker components are heavy and can damage materials like tile,
sandstone, and brick if not handled correctly. Move the Leg Assemblies with care
so that you do not cause damage to the surface.
2. Double check to make sure the Leg Assemblies are correctly positioned with the Door-Sentry car-
door protectors on the inside; the Leg Assemblies are
not
interchangeable.
To Next Page
Loading...
