STEP 14
(Lift Start Up)
1. Make sure the power unit reservoir is full with 12 quarts
of 10-WT hydraulic oil or Dexron-III automatic transmission
fluid.
2. Lubricate all friction points on the lift with a 90-WT Gear
Oil.
3. Test the power unit by depressing the push-button switch.
If the motor sounds like it is operating properly, raise lift
and check all hose connections for leaks. IF MOTOR GETS
HOT OR SOUNDS PECULIAR, STOP IMMEDIATELY AND
RE-CHECK ELECTRICAL CONNECTIONS.
To Raise Lift
Position vehicle with front tires at front stop bar.
1. Set parking brake or use wheel chock to hold vehicle in
position.
2. Before raising vehicle, be sure all personnel are clear
of the lift and surrounding area. Pay careful attention to
overhead clearances.
3. Raise the lift to the desired height by pressing the push
button on the power unit.
4. Check to make sure the safety is engaged BEFORE
ENTERING work area.
To Lower Lift
1. Raise the lift off the safety lock by pressing the UP push
button on the power unit. Make sure you raise the lift by
at least one inch to allow adequate clearance for the lock
to clear.
2. Before lowering the lift PAY CAREFUL ATTENTION
that all personnel and objects are kept clear. ALWAYS
keep a visual line of site on the lift AT ALL TIMES.
3. Press and hold the DOWN / SAFETY LOCK RELEASE
button.
4. Push the LOWERING HANDLE on the power unit until
the lift has descended completely.
16
VISUALLY CONFIRM THAT ALL PRIMARY
SAFETY LOCKS ARE ENGAGED BEFORE
ENTERING WORK AREA.
Suspension components us on this lift are
intended to raise and lower lift only and
are not meant to be load holding devices.
Remain clear of elevated lift unless visual
confirmation is made that all primary
Safety Locks are fully engaged and the lift
is LOWERED onto the safety locks, Refer to
installation /operation manual for proper safety
lock procedures and /or further instruction.
CAUTION!
During the START-UP procedure, observe all
operating components and check for proper installation
and adjustment. DO NOT attempt to raise vehicle until
a thorough operational check has been completed.
NOTE:
THE SAFETY ASSEMBLY AND SAFETY CABLE
MUST BE ADJUSTED AFTER THE POWER UNIT IS
HOOKED UP AND BEFORE ANY VEHICLES ARE
LIFTED TO ENSURE PROPER OPERATION.
To Next Page
Loading...
Need help?
General
