BendPak XPR-10XLS - To wire a Microswitch

XPR-10 Series Two-Post Lifts 58 P/N 5900951 — Rev. D — May 2019
To wire a Microswitch:
1. Locate the Microswitch Cable (14/4 SJO, UL 62, 300 VAC) supplied with the Lift and the
Powerside Safety Cover.
2.
On the Overhead Assembly , appropriately connect one end of the Microswitch Cable to the
Microswitch (or two Microswitches, for a 3 Phase Power Unit).
Refer to the diagrams in Wiring Diagrams for wiring information.
3. Route the Microswitch Cable from the Microswitch on the Overhead Assembly over to the
Powerside Post, down the Powerside Post, out the hole in the Post near the top of the Safety Lock
Release, through the Grommet in the Powerside Safety Cover, and to the Electrical Box on the
Power Unit.
The Powerside Safety Cover should already be in place.. Do not fully tighten the Powerside Safety
Cover in place at this point in the installation.
4. Once the Microswitch Cable is routed from the Microswitch to the Power Unit, clip the Microswitch
Cable using the clips on the Overhead Assembly and the inside of the Powerside Post.
Clipping the Microswitch Cable in place keeps it out of the way of the other components.
5.
On the Power Unit , open the Electrical Box and wire the Microswitch Cable per the instructions
in Connecting the Power Unit.