37
MAINTENANCE INSTRUCTIONS
• Always keep bolts tight. Check periodically.
• Always keep lift components clean.
• Always if oil leakage is observed, call local service
representative.
• Always if electrical problems develop, call local
service representative.
• Always replace ALL FAULTY PARTS before lift is put
back into operation.
• Daily: Make a visual inspection of ALL MOVING
PARTS and check for excessive signs of wear.
• Daily: Check Safety Locks to insure they are in good
operating condition.
• Daily: Check cables and sheaves for wear. Replace
worn parts as required with genuine BendPak parts.
• Daily: Inspect adapters for damage or excessive
wear. Replace as required with genuine BendPak
parts.
• Weekly: Lubricate all rollers with general purpose oil
or WD-40.
• Weekly: Check all cable connections, bolts and pins
to insure proper mounting.
• Monthly: Check equalizer cable tension. Adjust per lift
installation instructions.
• Monthly: Lubricate locking latch shafts. Push latch
handle several times for oil to penetrate pivot points.
• Every 3 Months: Check anchor bolts for tightness.
Anchors should be torqued to 90 ft/lbs.
• Semi-Annually: Check uid level of lift power unit and
rell if required per lift installation instructions.
• Replace all caution, warning or safety related decals
on the lift if unable to read or missing. Reorder labels
from BendPak.
• Refer to ANSI/ALI ALOIM booklet for periodic
inspection checklist and maintenance log sheet.
CAUTION!
If you are not completely familiar with automotive lift
maintenance procedures; STOP: Contact factory for
instructions. To avoid personal injury, permit only
qualied personnel to perform maintenance on this
equipment.
To Next Page
Loading...
Need help?
General
