EasyManua.ls Logo

Benelli Pepe - Replacing the Headlight Bulbs; Perform this operation when the vehicle is stationary and the ignition key is in the OFF position.; Replace the bulb with another of the same type.

Benelli Pepe
88 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
62
REPLACING THE HEADLIGHT BULBS
REPLACING THE HEADLIGHT BULBS
Perform this operation when the vehicle
is stationary and the ignition key is in the
OFF position. Do not force the wires. After
completing the operation, ensure that the wires are
properly connected.
Remove the shield (1) by unloosing the leg guard-fixing
screws(2) and slightly pulling upwards the front shield.
Remove the rubber cap of the bulb with the hands.
Turn the bar holding the bulb in an anticlockwise direction
and remove the bulb to be replaced.
(Turn the bulb socket in an anticlockwise direction and
replace the defective bulb).
Replace the bulb with another of the same type.
FEU AVANT - RE M PLACE ME NT
DES AMPOULES
MAINTENANCE
ENTRETIEN
FEU AVANT - REMPLACEMENT DES AMPOULES
Oration à effectuer véhicule à l'ar-
rêt et clé de contact retie. Ne pas
forcer sur les bles électriques. Une fois
l'oration terminée, s'assurer que les câbles sont
brancs correctement.
Ôter lcran (1 ) en desserrant les vis (2) de fixation sur le
tablier et en le soulevant légèrement vers le haut.
ôter la protection en caoutchouc de l'ampoule.
Tourner dans le sens inverse des aiguilles d'une montre
la barrette fixant l'ampoule et extraire l'ampoule à rem-
placer.
(Tourner la douille en sens contraire d'horloge et rem-
placer l'ampoule défectueuse).
Effectuer le remplacement avec une ampoule du
même type.

Related product manuals