4.
Quick Installation Instruction
4.1
How to set up the front wheel
1. Insert the front wheel in-between the front
fork, make sure the brake disc sits between the
brake pads
2. Take the quick release lever, slide off the
ends, and insert the lever rod through the hub
from opposite side of the brake disc. Then, slide
the spring and nut onto the rod, tighten the nut.
Continue to tighten the nut while opening and
closing the lever until a good resistance is
achieved.
3. Make sure the lever is flipped up
towards the frame to avoid snapping
To Next Page
Loading...
