27 - 28
SPECIFICATION
Size and Weight
Length
Width
Height
Wheelbase
Dry Weight
Engine
Type
Model
Bore × Stroke
Displacement
Maximum Power
Maximum Torque
...............................................................................
...................................................................................
...............................................................................
..........................................................................
............................................................................
..............................
............................................................................
..........................................................
.........................................................................
..............................................
...........................................
Tire
2050mm
810mm
1065mm
1360mm
135kg
Single-cylinder, Four-stroke,Two-valve
157FMJ-2B
Ø57.3×58mm
150ml
9.6kW/8000 r/min
12.8N.m/6500 r/min
Front tire
Rear tire
Fuel Tank (include reserve tank)
Fuel Type
Front Brake Type
Rear Brake Type
100/80-17
130/70-17
13.5L
Regular unleaded gasoline only
Disk Brake
Disk Brake
......................................................................
.......................................................................
.......................................
..............................
.......................................................
.......................................................
Fuel
Brake
STORAGE
Always store your vehicle in a cool, dry place and, if
necessary, protect it against dust with a porous
cover.
Short-term
Long-term
Before storing your vehicle for several months:
1. Change engine oil.
TIRE INFORMATION
COLD TIRE PRESSURE
[FRONT] 190kpa(1.9kgf/cm
2
) [REAR] 210kpa(2.1kgf/cm
2
)
X
O
X
2. Lubricate drive chain.
3. Drain fuel in fuel tank and carburetor out.
Install the fuel tank cover again.
4. Detach the spark plug and add one teaspoon of
(15~20cm
3
) clean engine oil to cylinder. Kick the
starting lever for several times to distribute oil in the
cylinder, and install the spark plug again.
5. Remove the battery. Keep the battery in proper
place which can avoid freezing and the direct sun-
light. Charge the battery or examine the electrolyte
level(if equipped with lead-acid battery).
6. Clean and dry the vehicle. Wax the surface of the
paint.
7. Inflate tire to the required pressure. Put the vehi-
cle on a block to make two tires off the ground.
8. Cover the vehicle (no plastic or coating material)
and keep it in the place consistent temperature and
low humidity. Do not keep your vehicle under direct
sunlight.
Use the vehicle after storage
1. Take off the cover and clean the vehicle. Change
engine oil if you keep your vehicle for more than four
months.
2. Examine the electrolyte level and charging as
needed. Install the battery.
3. Wash away the anti-rust agent in fuel tank, and
add new petrol into fuel tank.
Ignition System Type
Compression Ratio
CDI
9.2:1
...............................................................
................................................................
To Previous Page
Loading...
