6 - 17
Periodic maintenance and adjustment
EN
6
Tire inspection
B
A
C
1
2
3
1. Tire tread depth
2. Side well
3. Wear warning
The tires must be checked before each
ride. If the tread depth reaches the speci-
ed limit, if the tire has a nail or glass frag-
ments in it, or if the sidewall is cracked,
have a Benellidealer replace the tire im-
mediately.
Minimum tire tread depth
(front and rear):
1.6 mm
NOTE
The tire tread depth limits may dier from
country to country. Always comply with
the local regulations.
WARNING
• Have a Benelli dealer replace
excessively worn tires. Besides
being illegal, operating the vehi-
cle with excessively worn tires
decreases riding stability and can
lead to loss of control.
• The replacement of all wheel and
brake related parts, including the
tires, should be left to a Benelli
dealer, who has the necessary pro-
fessional knowledge and expe-
rience to do so.
• Ride at moderate speeds after
changing a tire since the tire sur-
face must rst be “broken in” for it
to develop its optimal characteri-
stics.
Tires age, even if they have not been used
or have only been used occasionally.
Cracking of the tread and sidewall rubber,
sometimes accompanied by carcass de-
formation, is an evidence of ageing. Old
and aged tires shall be checked by tire
specialists to ascertain their suitability for
further use.
WARNING
• The front and rear tires should
be of the same make and design,
otherwise the handling characte-
ristics of the motorcycle may be
dierent, which could lead to an
accident.
• Always make sure that the valve
caps are securely installed to pre-
vent air pressure leakage.
Front tire:
Size:
120/70 - ZR17 58W
TRAIL Size:
110/80- R19 59V
To Next Page
Loading...
Need help?
General
