Why does my Bennett Read Tough 35 Vacuum Cleaner have weak suction power?
Weak suction power in your Bennett Read Vacuum Cleaner can be due to a dirty or clogged microparticle filter. Clean the microparticle filter. Also, check for any obstructions in the flex hose, vacuum nozzle, or extension pipes. Remove these parts and clear any blockages.
Why is dust escaping from my Bennett Read Tough 35 while vacuuming?
Visible dust escaping from your Bennett Read Vacuum Cleaner while vacuuming can occur if the microparticle filter is not installed correctly or is dirty. Check the microparticle filter, situated underneath the motor unit. If the filter is present but dirty, clean it.
How to fix a Bennett Read Tough 35 that is not switching on?
If your Bennett Read Vacuum Cleaner is not switching on, make sure the power cord is firmly plugged into the wall socket and that the wall socket is switched on. Check the electrical plug.
What to do if my Bennett Read Tough 35 Vacuum Cleaner switches off during operation?
If your Bennett Read Vacuum Cleaner switches off during operation, it may be due to the thermal cut-off switch activating. This can happen if the filter is dirty or clogged. Clean or replace the microparticle filter. Another cause could be an obstruction in the flex hose or extension tubes. Check and clean these parts. The machine will switch on after cooling down. Continuing use without addressing the cause of overheating will damage the machine.
General| Brand | Bennett Read |
|---|---|
| Model | Tough 35 |
| Category | Vacuum Cleaner |
| Language | English |
Procedure for emptying the dirt tank, including using the drain plug and rinsing.
Instructions for cleaning the microparticle filter daily and weekly, including washing and drying.
To Next Page