Preparing the camera for use 3
English
Preparing the camera for use
Use only the specified battery for the camera, and always turn off the camera before
removing the battery.
Indicator State Description
Status LED No light The digital camera is off.
Solid green • The digital camera is ready to capture images.
• The digital camera is powering on, or is in the
power-saving mode.
Blinking green • The digital camera cannot focus.
• The digital camera is capturing a video clip.
• The flash is charging, or the USB communication/
transfer is in progress.
Self-timer LED Blinking red The self-timer function is activated.
• It is normal for the camera to become warm during operation, because metal camera
casing can conduct heat.
• The LCD display on this camera is manufactured with sophisticated technology, and
more than 99.99% of the pixels on the LCD display meet standard specifications. Yet, it
is possible that less than 0.01% of the pixels on the LCD display may have some light
spots or show unusual colors. This is normal and does not indicate display
malfunction, nor will this affect the pictures you take with the camera.
A
To install the battery:
1. Open the battery/card cover (A).
2. Insert the battery in the correct direction by matching
the + - label on the battery slot (B).
3. Push the battery all the way down, until the battery
lock lever clicks into place (C).
4. Close the battery/card cover (D).
B
T1460 UM-EN.book Page 3 Thursday, September 23, 2010 6:31 PM
To Next Page
Loading...
Need help?
General
