37 Menu operation
SYSTEM SETUP: ADVANCED menu
Menu Settings
• Menu Position: Sets the On-Screen Display (OSD) menu position.
• Menu Display Time: Sets the length of time the OSD will remain active after
your last key press.
• Reminder Message: Sets the reminder messages on or off.
Source
Rename
Renames the current input source to your desired name.
On the Source Rename page, use / / / to set the desired characters for
the connected source item.
When done, press OK to save the changes.
Auto Source Allows the projector to automatically search for a signal.
Audio
Settings
• Mute: Temporarily turns off the sound.
• Volume: Adjusts the sound level.
Light Source
Information
• Light Source Timer: See Getting to know the light source hour on page 40.
HDMI
Settings
• HDMI Range: Selects a suitable RGB color range to correct the color accuracy.
• Auto: Automatically selects a suitable color range for the incoming HDMI
signal.
• RGB Limited: Utilizes the Limited range RGB 16-235.
• RGB Full: Utilizes the Full range RGB 0-255.
• YUV Limited: Utilizes the Limited range YUV 16-235.
• YUV Full: Utilizes the Full range YUV 0-255.
• CEC: When you connect an HDMI CEC-compatible device to your projector
with an HDMI cable, turning on the HDMI CEC compatible device automatically
turns on the projector, while turning off the projector automatically turns off the
HDMI CEC compatible device.
• Power On Link/Power Off Link: When you connect an HDMI
CEC-compatible device to your projector with an HDMI cable, you can set the
behavior of powering on/off between the device and the projector.
• From Projector: When the projector is turned on/off, the connected device
will be activated/shut down, too.
• From Device: When the connected device is turned on/off, the projector
will be activated/shut down, too.
Password See Utilizing the password function on page 22.
To Next Page
