BenQ LU935 - Page 14

14 Positioning your projector
LU935ST
• The screen aspect ratio is 16:10 and the projected picture is in a 16:10 aspect ratio
For example, if you are using a 120-inch screen, the recommended projection distance is 2197
mm.
If your measured projection distance is 2500 mm, the closest match in the "Projection distance
(mm)" column is 2563 mm. Looking across this row shows that a 140'' (about 3.6 m) screen is
required.
• To optimize your projection quality, we suggest you do the projection within non-gray area.
• All measurements are approximate and may vary from the actual sizes.
BenQ recommends that if you intend to permanently install the projector, you should physically test the
projection size and distance using the actual projector in situ before you permanently install it, so as to make
allowance for this projector's optical characteristics. This will help you determine the exact mounting position so
that it best suits your installation location.
Screen size Projection distance (mm)
Diagonal
W (mm) H (mm)
Min length
Average
Max length
Inch mm (max. zoom) (min. zoom)
30 762 646 404 523 549 575
40 1016 862 538 698 732 767
50 1270 1077 673 872 915 958
60 1524 1292 808 1047 1098 1150
80 2032 1723 1077 1396 1465 1534
90 2286 1939 1212 1570 1648 1725
100 2540 2154 1346 1745 1831 1917
110 2794 2369 1481 1919 2014 2109
120 3048 2585 1615 2094 2197 2300
130 3302 2800 1750 2268 2380 2492
140 3556 3015 1885 2443 2563 2684
150 3810 3231 2019 2617 2746 2875
160 4064 3446 2154 2791 2929 3067
170 4318 3662 2289 2966 3112 3259
180 4572 3877 2423 3140 3295 3451
190 4826 4092 2558 3315 3479 3642
200 5080 4308 2692 3489 3662 3834
250 6350 5385 3365 4362 4577 4792
300 7620 6462 4039 5234 5492 5751
• To optimize your projection quality, we suggest you do the projection within non-gray area.
• All measurements are approximate and may vary from the actual sizes.
BenQ recommends that if you intend to permanently install the projector, you should physically test the
projection size and distance using the actual projector in situ before you permanently install it, so as to make
allowance for this projector's optical characteristics. This will help you determine the exact mounting position so
that it best suits your installation location.