30 Operation
The info page displays the information and status of this projector.
For more information, visit http://www.crestron.com & www.crestron.com/getroomview.
Shutting down the projector
1. Press on the projector or on the remote control
and a confirmation message will appear prompting you. If
you don't respond in a few seconds, the message will
disappear.
2. Press or a second time. The power indicator
flashes orange, the projection light source shuts down,
and the fans will continue to run for approximately 90
seconds to cool down the projector.
3. Once the cooling process finishes, the power indicator
becomes a steady orange and fans stop. Disconnect the power cord from the power outlet.
Direct power off
The AC power cord can be pulled out right after the projector is turned off. To protect the light source,
wait about 10 minutes before re-starting the projector. If you attempt to re-start the projector, the fans
may run for a few minutes to cool down. In such cases, press or again to start the projector
after the fans stop and the power indicator turns orange.
• To protect the light source, the projector will not respond to any commands during the cooling process.
• Avoid turning on the projector immediately after turning it off as excessive heat may shorten light source life.
• Light source life results will vary depending on environmental conditions and usage.
Press Exit to go back to the remote
network operation page.
To Next Page
Loading...
