Maintenance 47
7. Use the handle to slowly pull the lamp out of
the projector.
• Pulling it too quickly may cause the lamp to break and
scatter broken glass in the projector.
• Do not place the lamp in locations where water might
splash on it, children can reach it, or near flammable
materials.
• Do not insert your hands into the projector after the
lamp is removed. If you touch the optical components
inside, it could cause color unevenness and distortion of
the projected images.
8. As shown in the figure, lower the new lamp.
9. Reconnect the lamp connector to the
projector.
10. Tighten the screw that secures the lamp.
11. Ensure the handle is fully laid flat and locked
in place.
• Loose screw may cause a bad connection, which could
result in malfunction.
• Do not over tighten the screw.
12. Replace the lamp cover on the projector.
13. Tighten the screw that secures the lamp cover.
• Loose screw may cause a bad connection, which could
result in malfunction.
• Do not over tighten the screw.
To Next Page
Loading...
