34
6.0 EXPRESSION OF DEFECTIVES
Number of defects
Percent of defects = ------------------------------------------ X 100%
Number of products inspected
7.0 INSPECTION STANDARD
Unless otherwise specified, the inspection standard will be defined by MIL-STD-105E,
NORMAL INSPECTION LEVEL Ⅱ, SINGLE SAMPLING PLAN.
7.1 Acceptance Quality Level
7.1.1 Critical Defect:
When a critical defect is found, this must be reported immediately upon detection, the
lot or batch shall be rejected and further shipments shall be held up pending instructions
from the responsible person in relevant department.
7.1.2 under normal sampling
Critical Defective : 0% AQL
Ma
or Defective : 0.65% AQL
Minor Defective : 2.5% AQL
8.0 GENERAL RULES
8.1 The inspection must be carried out by trained inspectors who have good knowledge about
the product.
8.2 The inspection must be based upon the documents concerning the completely assembled
and packed product.
8.3 When more defects appear with the same unit only the most serious defect has to be taken
into account.
8.4 Defects found in accessory packed with the product such as Cable, Connector, Manual, CD
and the like, and being inspected as a part of the complete product, must be included in the
evaluation.
8.5 The evaluation must be within the limits of the product specification and, for not specified
characteristics, refer to the sample machine or the judgment of BENQ QA Engineer. But any
kind of proposals or judgments must be reasonable and acceptable by both sides.
To Next Page
Loading...
