Operation44
4. Press ▼ to highlight Timer Position and set the timer position by
pressing ◄/►.
5. Press ▼ to highlight Timer Counting Direction and select your
desired counting direction by pressing ◄/►.
6. Press ▼ to highlight Sound Reminder and decide if you want to
activate sound reminder by pressing ◄/►. If you select On, a double
beep sound will be heard at the last 30 seconds of counting down/up,
and a triple beep sound will be produced when the timer is up.
7. To activate the presentation timer, press ▼ and press ◄/► to highlight
On and press MODE/ENTER.
8. A confirmation message appears. Highlight Ye s and press MODE/
ENTER on the projector or remote control to confirm. You will see
the message “Timer is On” appearing on the screen. The timer starts
counting when the timer is on.
To cancel the timer, perform the following steps:
1. Go to the System Setup: Basic > Presentation Timer menu and
highlight Off. Press MODE/ENTER. A confirmation message appears.
2. Highlight Ye s and press MODE/ENTER to confirm. You will see the
message “Timer is Off” appearing on the screen.
Selection Description
Count Up Increases from 0 to the preset time.
Count Down Decreases from the preset time to 0.
To Next Page
Loading...
