BenQ MX852UST+ - Page 68

Maintenance68
The warning messages below are for reference only. Please follow the actual
on-screen instructions to prepare and replace the lamp.
Status Message
Install a new lamp for optimal
performance. If the projector is normally
run with Economic selected (See
"Setting Lamp mode as Economic or
SmartEco" on page 66), you may
continue to operate the projector until
the next lamp warning appears.
Press MODE/ENTER to dismiss the
message.
It is strongly recommended that you
replace the lamp at this age. The lamp is
a consumable item. The lamp brightness
diminishes with use. This is normal lamp
behavior. You can replace the lamp
whenever you notice that the brightness
level has significantly diminished.
Press MODE/ENTER to dismiss the
message.
The lamp MUST be replaced before the
projector will operate normally.
Press MODE/ENTER to dismiss the
message.
Order a new lamp at www.benq.com
OK
Order Replacement Lamp
Lamp >XXXX Hours
Notice
OK
Notice
Replace Lamp soon
Lamp > XXXX Hours
Order a new lamp at www.benq.com
OK
Notice
Replace Lamp Now
Lamp > XXXX Hours
Lamp usage time exceeded
Order a new lamp at www.benq.com
OK
Notice
Out of Lamp Usage Time
Replace lamp (Refer to user manual)
Then reset lamp timer
Order a new lamp at www.benq.com