Maintenance70
4. Loosen the two captive screws
that secure the lamp.
• Do not turn the power on with the
lamp cover removed.
• Do not insert your fingers between
the lamp and the projector. The
sharp edges inside the projector
may cause injuries.
5. Lift the handle so that it stands
up. Use the handle to slowly pull
the lamp out of the projector.
• Pulling it too quickly may cause the
lamp to break and scatter broken
glass in the projector.
• Do not place the lamp in locations
where water might splash on it,
children can reach it, or near
flammable materials.
• Do not insert your hands into the
projector after the lamp is
removed. If you touch the optical
components inside, it could cause
color unevenness and distortion of
the projected images.
6. Insert the new lamp into the
lamp compartment and make
sure it fits in the projector.
• Ensure the connectors are aligned.
• If you experience resistance, lift
the lamp and start again.
To Next Page
Loading...
