BenQ P211 - Connecting the Signal Cable; Connecting through D-SUB Signal Connector


5
Connecting the Signal Cable
Your Benq P211 provides both D-SUB and BNC signal connectors. The D-SUB or
BNC signals can automatically be detected by its microprocessor.
✏ Connecting through D-SUB signal connector
1) Make sure that the system power is turned off.
2) Connect the computer end of the D-SUB cable to the 15-pin output connector
on the video board of your computer.
3) Connect the monitor end of the D-SUB cable to the D-SUB receptacle on the
back of the monitor.
Installing the Monitor