11 Introduction
Remote control effective range
The remote control must be held at an angle within 30 degrees perpendicular to the projector's IR
remote control sensor(s) to function correctly. The distance between the remote control and the
sensor(s) should not exceed 8 meters (~ 26 feet).
Make sure that there are no obstacles between the remote control and the IR sensor(s) on the
projector that might obstruct the infra-red beam.
12. DEFAULT
Resets the current function to default
factory setting.
13. MENU
Turns on the On-Screen Display (OSD)
menu.
14. CINEMAMASTER
Displays the CinemaMaster menu. See
CinemaMaster on page 29.
15. HDR
Displays the HDR menu. See HDR on page
31.
16. LIGHT MODE
Selects a suitable light source power from
among the provided modes.
17. ECO BLANK
Used to hide the screen picture.
Do not block the projection lens from
projecting as this could cause the
blocking object to become heated and
deformed or even cause a fire.
18. KEY LIGHT
Turns on the remote control backlight for a
few seconds. To keep the backlight on, press
any other key while the backlight is on. Press
the key again to turn the backlight off.
• Operating the projector from the front
To Next Page
Loading...
