22 Operation
Shutting down the projector
1. Press and a confirmation message will appear
prompting you. If you don't respond in a few seconds, the
message will disappear.
2. Press a second time. The power indicator flashes
white, the projection light source shuts down.
3. Once the cooling process finishes, the power indicator
becomes a steady blue and fans stop. Disconnect the
power cord from the power outlet.
• To protect the light source, the projector will not respond to any commands during the cooling process.
• Avoid turning on the projector immediately after turning it off as excessive heat may shorten light source life.
• Light source life results will vary depending on environmental conditions and usage.
To Next Page
Loading...
