1 - Introduction
9
1 - Introduction
Using This Manual
Layout This manual is divided into 9 sections. Each section contains topics related to the section. The sections are as
follows:
• Introduction
• Technical Specifications
• Installation
• Keypad Operation
• Parameter Groups
• Parameter Descriptions
• Theory of Operation
• Troubleshooting & Maintenance
• Appendices
Notations There are 3 notations used in this manual to highlight important information. These notations appear as the
following:
WARNING: Indicates situations in which high voltages can cause physical injury, or death.
CAUTION: Indicates situations in which damage to equipment may occur.
NOTE: Marks an important point in the documentation.
WARNING: HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
• Only qualified personnel familiar with low or medium voltage equipment are to perform work described in this
set of instructions.
• Apply appropriate personal protective equipment (PPE) and follow safe electrical work practices. See NFPA
70E.
• Turn off all power before working on or inside equipment.
• Use a properly rated voltage sensing device to confirm that the power is off.
• Before performing visual inspections, tests, or maintenance on the equipment, disconnect all sources of
electric power. Assume that circuits are live until they have been completely de-energized, tested, and
tagged. Pay particular attention to the design of the power system. Consider all sources of power, including
the possibility of backfeeding.
• Replace all devices, doors, and covers before turning on power to this equipment.
Failure to follow these instructions may result in death or serious injury
To Next Page
Loading...
Need help?
General
