BEP TS1 - Specifications; Electrical Specifications; Maximum Tank Depths

INST-TS1-V13
18/11/10
Page 3
1. Features
 12V and 24V operation
 Extremely low profile only 20mm high once mounted
 Operating distance of 0mm to 2000mm maximum
 Programmable tank dimensions via windows application
 Linear and non linear tank calibration at 5 levels
 Supports metal and plastic tanks
 Supports tanks wall thickness up to 6mm (or larger if spacer is used and top limit
adjusted)
 Industry standard SAE-5 stud mounting pattern with gasket seal and washers.
 Supports analogue gauge types 10-180, 300-10, 240-33
 Supports Digital meter that require 0-5 volt inputs
 Operating temperature range of 4°c to 65°c
2. Specifications
Electrical
 10V
MIN
to 32V
MAX
DC.
 Ignition protected to ISO 8846
 Fire Resistance tested to ABYC, US Coast guard and ISO10088
 Output types: Analogue 10-180, 300-10, 240-33 ohm gauges and 0-5volt
Environmental
Resistant to Petrol, Diesel, Water, and Chemical Toilet.
Maximum Tank depths
 Operating distance of 0mm to 1100mm for Petrol tanks
 Operating distance of 0mm to 2000mm for Water tanks
 Operating distance of 0mm to 2000mm for Diesel tanks
 Operating distance of 0mm to 1500mm at 55°c
Note: Liquids that may have a sound absorbing surface will limit tank depth or in the worst
case provide no return signal eg. foam bubbles or porous sludge.
Permanent liquid surfaces that are more than 3 degree’s off level will have a tank depth de-
rating effect.
Liquids that have higher viscosities than water (e.g. oil) may not propagate liquid ripples that
create a strong return signal. This will also have a tank depth de-rating effect.
Don’t use on tanks shallower than 200mm in depth as angular reflections will reduce
accuracy.