Need help?Do you have a question about the BEP TS1 and is the answer not in the manual?
Covers voltage input (10-32V DC), ignition protection, fire resistance, and output types.
Specifies operating distances for different liquids and temperatures, noting de-rating.
Specifies the required 42mm cutout diameter and mounting hole pattern.
Illustrates correct placement of gasket, acoustic protrusion, and glue barrier.
Ensures acoustic protrusion is centered and not recessed into the tank aperture.
Details the procedure for tightening mounting screws until contact plus two full turns.
Specifies a maximum torque of 0.5 Newton meter for mounting screws.
Mount at deepest point, especially for moving/baffled tanks, to average wave slop.
Mount at least 150mm from tank walls, baffles, or piping for optimal signal.
Use the correct BEP gasket and provided washers to prevent damage to the lid.
Ensure the acoustic protrusion does not make contact with the tank frame.
Ensure power is removed before connecting the TS1 to prevent device damage.
Diagram for 12V system wiring, showing connections to meter and power.
Diagram for 24V system wiring, noting gauge requirements for dropping resistors.
To Next Page
General