acquisition.
In program submenu, use key "ESC" to get back to the programs menu. Strike any key
to clear the error messages which may be displayed
on
LCD screen.
3.3.2 Functions menu:
3.3.2.1 Create a program:
When executing the "create a program" function, the program submenu is
acceded, starting with the identification. The initial identification "Pxx NO NAME"
is given to the program and all parameters are established to zero; the program
number is allocated automatically.
3.3.2.2 Delete a program:
When executing the "delete a program" function, the programs menu is
acceded and the number
of
the first program in memory is blinking to point
out the deletion mode. Use key "SELECT"
to
select a program and key
"ENTER" to accede and confirm deletion
of
the selection. Use key "ESC" to
unconfirm a deletion and to leave the function. When leaving the function, the
number
of
the actual program on LCD screen cease to blink.
3.3.2.3 Select operating mode:
When executing the "select operating mode" function, which is available only for
the automatic units, the actual selection is blinking to point out
the
acquisition
mode. Use key "SELECT" to get through the operating modes, which are
automatic, semi-automatic and manual; the validation
of
the selected operating
mode is performed automatically. Use key "ESC" or "ENTER" to leave the
function and get back to the program menu. •
3.3.3 Programs menu:
3.3.3.1 Program identification:
For a selected program, · set the identification, using the numeric keyboard
characters chart; press numeric key until the desired character is selected (4
times for the numeric value). Use key "ENTER" to validate the character and to
validate the characters string
at
the end(the new characters string is blinking). In
a middle
of
an acquisition, use key "ESC" to come backward and erase one or
several characters.
Example: EXAMPLE 1
(9 characters)
-+
keys
2,
2, ENTER
keys
8, 8,
8, ENTER
keys
1,
ENTER
keys 5, ENTER
keys
6,
ENTER
keys 4, 4, 4, ENTER
keys 2,
2,
ENTER
10
E
X
A
M
p
L
E
To Next Page
Loading...
