Berkel 823 - Installation; Testing For Operation

I. INSTALLATION
1. When the slicer 'has·=be~ri unpa.cked and removed from its
shipping carton, i"t ·should be checked carefully for any
damage that may have occurred.during shipmen~. DO NOT
connect the power cord or attempt to operate the slicer
prior to this examination •. - .
2. Carefully check all slicer components such as the product
table, pusher, sharpener, slice _thickness index knob,
etc. , to make certain they move freely. and that there are
no obstructions. Lubricate the pusher· slide bar (on the
product·table) and the square and round table support
rails. (underside of slicer) with Berkel Food Machine Oil.
NOTE:. DO NoT USE ANY. OTHER TYPE. OIL ON THIS
MACHINE, BERKEL FOOD MACHINE OIL IS A u.s.D.A •. :
ACCEPTED FORMULA FOR FOOD PROCESSING EQUIPMENT.
NO OTHER TYPE OIL IS AUTHORIZED, BERKEL FOOD
MACHINE OIL CAN BE PURCHASED IN PINTS (PART NUMBER
4675-0183) OR GALLONS (PART NUMBER .4675-0184).
II.· TESTING FOR OPERATION
1. Make sure that the ON-OFF switch is in the OFF position,
and the thickness control knob is turned as far to the
right as possible. This positions the gauge plate so
that the knife is not exposed during testing.
2. P'iug power cord into grounded 120V/AC electrical outlet,
·' switch ON.
3. . Slide product table back and forth holding on . to the
product table·. handle. ;tf there is any~ rough operation
or obstructiqn, shut off I disconnect power cord and call
your Berke! serviceman~ (List included with machine)
(1)