Need help?Do you have a question about the Bernard Controls AQ10 and is the answer not in the manual?
General| Brand | Bernard Controls |
|---|---|
| Model | AQ10 |
| Category | Switch |
| Language | English |
Actuators correspond to one of two configurations: Without Positioner or With Positioner.
Electrical connection requires a qualified professional; open cover, install cable glands, and wire actuator.
Wiring must follow the diagram matching actuator characteristics; integrate thermal protector and torque limit switches.
Details wiring for actuators with the positioner option, covering power terminal blocks.
Check power supply voltage, connectors, cable glands, and motor rotation direction after completing wiring.
Calibrate cams to trigger switches at end positions; do not electrically stop on mechanical stops.
Adjust mechanical stops to contact output sleeve and back off 1.5 turns; ensure motor stops on limit switches, not mechanical stops.
Calibrate the positioner by setting voltage, validating open/closed positions, and performing an AUTOSET.
To Next Page