Need help?Do you have a question about the Bernard Controls AQ Switch Series and is the answer not in the manual?
General| Brand | Bernard Controls |
|---|---|
| Model | AQ Switch Series |
| Category | Switch |
| Language | English |
Details the standard delivery method for AQ actuators, typically in a cardboard box.
Specifies ideal storage conditions: sheltered, clean, dry, and protected from temperature fluctuations.
Notes lifetime lubrication and annual testing of motor operation as key maintenance points.
Guides on modifying the position indicator cap to reflect the actuator's closing direction.
Outlines the two primary electrical configurations the actuator will present during commissioning.
Describes the location and connection of the power terminal block on the electronic assembly.
Guides on adjusting cams to set end position switches accurately for actuator stopping.
Guides on setting the potentiometer circuit board for accurate actuator position feedback.
Explains selection between 0-10V/0-20mA and 4-20 mA signals for valve control.
Details the function of dip switches for setting closing type, fail position, and rotation direction.
Explains how cams and switches trigger the torque limiter to prevent over-torque conditions.
Presents the wiring schematic for actuators that do not include a positioner.
Illustrates the wiring diagram for three-phase supply with a positioner.
To Next Page