Bernard Controls AQ100 - User Manual

AQ Switch
RANGE
Start Up Guide
SUG_17003 EN - Ind. C
Art: 5100466

Bernard Controls AQ100 Specifications

General

Brand	Bernard Controls
Model	AQ100
Category	Switch
Language	English

Summary

Safety

Assembly on the Valve or Damper

Electrical Commissioning

Before wiring

Pre-wiring steps including opening the cover and installing cable glands.

Wiring without positioner option

Step-by-step guide for wiring actuators that do not feature a positioner.

Wiring with positioner option

Instructions for wiring actuators that are equipped with a positioner.

After wiring

Verification steps after wiring to ensure correct actuator operation and motor direction.

Calibration of Travel Limits

Calibration of cams corresponding to end position switches

Procedure for calibrating cams to trigger end position limit switches correctly.

Calibration of mechanical stops

Steps to calibrate mechanical stops, ensuring they don't interfere with limit switch operation.

Calibration of positioner (OPTION)

Detailed steps to calibrate the positioner, involving local commands and voltage checks.

Calibration of Position Options

Position feedback potentiometer (OPTION)

TAM position transmitter (OPTION)

Positioner board setting (OPTION)

Torque Limiting Device (Except on AQ5;10;15)

Torque limiter operation

Torque limiter adjustment

Procedure for adjusting torque limits for both closing and opening directions.