Need help?Do you have a question about the Bernard Controls AQ3L and is the answer not in the manual?
General| Brand | Bernard Controls |
|---|---|
| Model | AQ3L |
| Category | Switch |
| Language | English |
Details on how the AQL actuator is delivered and recommended storage conditions.
Information on actuator lubrication and checks for condensation build-up.
Instructions on using adapters to match the actuator to the valve shaft.
Guide to reorienting the position indicator cap for counter-clockwise valve closing.
Post-wiring checks for power supply, connectors, cable glands, and actuator operation.
Procedure to adjust individual cams for clockwise/counter-clockwise travel limits and signaling.
Explanation of the four cams and their functions: travel limit and signaling.
Specific steps for setting travel limit and signaling cams on AQ1L and AQ3L models.
Procedure for setting mechanical stops and cams on AQ7L actuators.
Instructions for setting up the positioner board, which is largely automatic.
Steps to initiate and verify the automatic setup of the positioner board.
Using SW2 dip switches to configure closing direction and fallback position.
Steps to troubleshoot and restart the actuator after torque limitation is triggered.
To Next Page