15
How to wire actuator with Positioner
The wiring must be done according to the wiring diagram of your
actuator.
See Chapter 11 for more information on the wiring.
1. Using a 3×0.5 mm flat blade screwdriver, connect the power
supply on terminals marked L1, L2 & L3 (3Ph) or L, N (1Ph)
according to your supply type.
2. Crimp a ring cable lug on the ground cable.
3. Remove the screw using a 4 mm hex key.
4. Install a washer between the head of the screw and the ring
cable lug.
5. Tighten the screw.
6. Tighten the sealing nut on the cable gland when you have
completed wiring.
To Next Page
Loading...
