sew&go1/3/5
1
3
2
4
Attention:
Turn power switch to off ("O")!
1. Removing the presser foot
2. Attaching the presser foot
4. Attaching the Seam guide right
Raise the presser foot using the presser foot
lifter.
Raise the lever (e) and the foot disengages.
Lower the presser foot holder (b) using the
presser foot lifter, until the cut-out (c) is directly
above the pin (d).
The presser foot (f) will engage automatically.
Raise the presser clamp (a) with the presser
foot lifter.
Removing and Attaching the presser foot
shank (b) as illustrated.
Attach the seam guide right (g) in the slot as
illustrated. Adjust as needed for hems, pleats,
quilting, etc.
3. Removing and Attaching the presser foot
shank
14
g
a
b
e
a
c
d
e
f
b
Changing the presser foot
To Next Page
Loading...
