43
sew&go1/3/5
Applique
- Turn stitch length dial to the desired length.
- Turn stitch selector dial to small zig zag width.
- Cut out the applique design and baste it to the
fabric.
- Sew slowly around the edge of the design.
- Trim excess material outside the stitching.
Make sure not to cut any stitches.
- Remove the basting thread.
- Tie top and bottom thread under the applique
to avoid unraveling.
Please Note:
No "S1" marking is shown on the stitch length
dial by model sew&go 1.
Stitch length dialStitch width dial
To Next Page
Loading...
