4. Then further down and around the bottom part of the take up
lever cover.
5. At the top of this movement, pass the thread from right to the
left through the slotted eye of the take-up lever and then
downwards again.
3. Pull the thread forward and down. This operation pulls the
thread into the thread tension.
7. Pull the end of the thread through the needle from front to
rear, and pull out about 10 cm of thread.
Use the face plate thread cutter to cut excess needle thread.
Use the needle threader to thread the needle (refer to next
page for instruction).
6. Guide the thread through the wire loop.
Machine Setup
15
To Next Page
Loading...
