Bernina Bernette 25 - Changing the Presser Foot

Turn power switch to off ("O") when carrying out any of the
below operations!
Raise the presser foot bar (a).
Attach the presser foot holder (b) as illustrated.
Lower the presser foot holder (b) until the cut-out (c) is directly
above the pin (d).
Press the black lever (e).
Lower the presser foot holder (b) and the presser foot (f) will
engage automatically.
Raise the presser foot.
Press the black lever (e) and the foot will disengages.
Attach the guide (g) in the slot as illustrated.
Adjust according to need for hems, pleats, etc.
Attention:
Attaching the presser foot holder
Attaching the presser foot
Removing the presser foot
Attaching the guideedge/quilting
edge/quilting
b
a
d
c
f
d
e
e
g
Changing the Presser Foot
Machine Setup
19